Technical Support:
158-7527-1139
Comprehensive and reliable evaluation of BrAC
High sensitivity and fast response to alcohol
Built-in temperature compensation, external humidity compensation supported
Very low power consumption (< 66mW)
Small size (17.8mm×15.2mm×6.5mm)
Intelligent automatic baseline calibration
Baseline value can be reset, storage status is configurable
Robust design, excellent long-term stability
Highly flexible assembly methods and communication interfaces
Detection Principle: MEMS Metal Oxide Semiconductor Sensor
Detection Range: 0-2000 ug/L BrAC relative equivalent value
Warm-up Time: 10 Sec.
Communication Protocol: I²C, UART
Voltage: 5.0V±0.2V, max. 20mV ripple
Power Consumption: Max. 100mW @5.0VDC (20mA)
Test Interval: 1 Sec.
Operating Temperature: -10 ~ +60 ℃
Operating Humidity: 5 ~95 % RH, non-condensing
Storage Temperature: -40 ~ 85 ℃
Storage Humidity: 5 ~95 % RH, non-condensing
Calibration Method: Intelligent baseline calibration, power-off storage with settable reference value
The MH201 gas sensor module based on MEMS gas-sensing elements is used to test H2 gas content in ambient air. Test data is communicated via I²C or UART interface. The MEMS element surface can be protected with a filter membrane. The gas sensor module can select SMD or ribbon cable assembly as needed.
The MCO02 gas sensor module based on MEMS gas-sensing elements is used to test CO gas content in the ambient air. Test data is communicated via I²C and UART interfaces. The MEMS element surface can be protected with a filter membrane. The sensor module can select SMD or ribbon cable assembly as needed.
The MCH4 methane sensor module based on MEMS gas-sensing elements is primarily used to test natural gas leaks, providing relative equivalent concentrations of methane gas in the air. Test data is communicated via I²C, UART, or high/low level interfaces. The MEMS element surface can be protected with a filter membrane. The sensor module can select pin or socket assembly as needed.
The MTHO3A module based on MEMS gas-sensing elements is used to test ambient temperature, humidity, and harmful substance content in the air. Test data is communicated via I²C or UART interface. The MEMS element surface can be protected with a filter membrane. The air quality sensor module can select plug-in or SMT assembly as needed.
